Guide :Freezers : 3.7 cu. ft. / 105 liter Upright Freezer F623UI-2

Bottom drawer hard to close

The bottom drawer is very difficult to close. As you open it the drawer falls to one side and then you have to lift it to close it. My old freezer which was the same model didn't have this problem.

Research, Knowledge and Information :


Help! Soft Close Full Extension Drawers Are HORRIBLE!


The drawers are extremely hard to open AND close. The drawers I have ... Soft Close Full Extension Drawers ... allow 1/2 recess on bottom, back notched, drawer box ...
Read More At : ths.gardenweb.com...

nightstand or filing cabinet, the bottom drawer is hard to ...


nightstand or filing cabinet, the bottom drawer is hard to close so I use magnets.
Read More At : www.close5.com...

LG Refrigerator - Freezer Door Stuck - YouTube


Jun 30, 2013 · In this short video we will show you a few steps to take if you notice that your freezer door is hard to open or close and ... Bottom Freezer Drawers ...

Liberty 20 in. Soft Close Ball Bearing Full Extension Drawer ...


Liberty Soft Close Ball Bearing Full Extension Drawer Slide is ... Soft-Close Drawer Slides are ... than letting hard to clean protean build up on ...
Read More At : www.homedepot.com...

Fisher Paykel Doube Drawer bottom stuck - Appliance Repair Forum


OK, here's my situation with a Fisher Paykel double-drawer dishwasher. Found bottom drawer to be very hard to open. With a little pull I've extended the drawer all ...
Read More At : forum.appliancepartspros.com...

Bottom drawer of stove was hard to open and close one of the ...


HELPING DO-IT YOURSELFERS SINCE 1999 Jenn-Air Range JGR8850ADB: Bottom drawer of stove was hard to open and close one of the four rollers was missing!.
Read More At : www.appliancepartspros.com...

How to Fix a Stuck Drawer - YouTube


Nov 15, 2007 · Home improvement expert Ron Hazelton shows three quick and simple ways to fix or free up a wooden drawer that's stuck or hard to open and close. For more ...

My bottom freezer door does not open and close smoothly (it ...


My bottom freezer door does not open and ... that seems to be what is making the door hard to open and close. ... drawers and mostly under the bottom drawer ...
Read More At : www.appliancepartspros.com...

Suggested Questions And Answer :


Bottom drawer hard to close


Check the drawer slides on each side for cracks or a screw that has come loose. The drawer should slide in a groove on each side firmly. Hope this helps. JT
Read More At : 3.7 cu. ft. / 105 liter Upright Freezer F623UI-2...

Cannot open bottom freezer drawer. Ice in tray


Remove all food from fridge and take it outside. leave it outside until ice is melted. this is the procedure and i have to do it every day im a Refrigeration Mechanic.
Read More At : 19.3 cu. ft. / 547 liter Upright Freezer 601F...

Inside rear panel bulging


Unplug the unit and take out all the drawers and remove the back (behind the drawers) panel carefully. (This back panel has foamy thermal insulation behind it and this will be probably be enmeshed with ice - you may have to wait awhile for this ice to melt before you can remove the panel, even after you have unscrewed it.When you have got the back panel off, you will see a large solid block of ice, probably halfway up the cooling coils, right down to the bottom of the exposed space. You have to melt all this ice (I used a hair dryer to blow warm air onto the ice (have towels and a bucket ready to mop up the melted water, otherwise it will run over the floor. When you have melted all this ice, you will see a drain hole at the bottom of the exposed space. This will have ice in it and it must be cleared. Then replace the back panel and all should be OK. The panel bulges because ice/water is accumulating behind the panel, water, when it freezes, expands, forcing the panel forwards.I reckon it's a Hotpoint Design fault. What is supposed to happen is that during the heating cycle, melted ice drops down from the cooling coils and down the drain hole onto a plate over the compressor unit, where it evaporates. BUT, during the cooling cycle, a fan circulates cold air from the cooling coils, through the entire unit, which includes the chamber behind the panel that is below the coils. Thus this chamber gets cold (-18 deg.C) so that water dripping down during the heating cycle is frozen before it has a chance to fall down the drain hole.I now defrost in this manner every six months or so. Sadly, very sadly, Hotpoint, like other white goods manufacturers (Baxi Potterton boilers for instance) do not reply to my enquiries.Hope this helps.
Read More At : 6.92 cu. ft. / 196 liter Upright Freezer FZA80...

ICE BUILDUP ON BOTTOM OF FREEZER, DRAIN HOLE FROZEN


There is normally a small filiament of metal which is attached to the defrost element and conducts heat down the drainpipe preventing ice build up. You can pour some boiling water onto this area and even wriggle a piece of plastic tubing down the drain pipe to dislodge any blockage. For future prevention, you can attach a piece of copper wire around the defrost element (in the absence of the original filiament) and extend it down the drainpiple
Read More At : 13.7 cu. ft. / 388 liter Upright Freezer 23429...

Freezer outside walls are very hot. Not maintaining temp


Hi, The walls are getting hot because that is where the condesor coils are. The condensor coils are where the heat is disperst that is trap as the coolant pumps through the evaporator coils inside. The fact that it is holding 0 degrees is a good sign. Is this freezer in a garage? Check the door seals to make sure no heat is getting into the freezer other then when the door is opened. I hope this helps you. Please let me know if I can assist you further. Vic
Read More At : 20.3 cu. ft. / 575 liter Upright Freezer 23024...

Hotpoint FAZ50 Frost Free Freezer


IF NOT THE THE DEFROST TIMER YOUR DEFROST HEATER OR DEFROST TERMINATOR IS BAD,REMOVE BACK PANEL INSIDE THE FREEZER YOU WILL SEE A LONG SINGLE OR DOULE POLE SHAFT THIS IS YOUR HEAT REMOVE BOTH LEADS ONE ON EACH END PUT YOUR VOLT METER ON OMES AND PUT ONE LEAD ON EACH END IF YOU GET ANY KIND OF READING YOUR HEATER IS STILL GOOD AND THE LITTLE ROUND CLIP ON TERMANATOR IS BAD, IF NO READING THE HEATER IT IS BAD,REPLACE-GET THE MODEL NUMBER INSIDE FREEZER AND GO TO LOCAL APPLIANCE PARTS STORE TO GET HEATER-REPLACE AND PUT BACK TOFETHER AND YOU SHOULD BE GOOD TO GO,ALSO MAKE SURE THE FREEZER FAN IS NOT STUCK AND TURNING,IF NOT TURNING SPIN IT WITH YOUR FINGER AND SEE IF YOU CAN GET IT GOING AGAIN,LET ME KNOW
Read More At : 4.87 cu. ft. / 138 liter Upright Freezer FZA50...

GE upright freezer


If this is a frost free model the fan could be bad. If not frost free it is probably low on freon. I don't recomment fixing this as you can never really trust the freezer again. Most of the time the leak can't be found and adding freon is only a temp solution.
Read More At : 16.7 cu. ft. / 473 liter Upright Freezer FUF17DMRWH...

2 yrs old, huge fridge w/ 2 freezer drawers on the bottom. Both drawers are warming - set at -5 but now temp is 4. What can I do?????


What brand? trying cleaning the condenser coil
Read More At : 19.3 cu. ft. / 547 liter Upright Freezer 601F...

Freezer defrosting our 3 year of freezer is defrosting: causing all the food to become soft and lose it frozen state. also, there are ice chunks at the bottom shelf of the freezer and the last 1/3 of the door does not close tightly.


Need to defost the whole freezer get the door to close correctly...
Read More At : 20 cu. ft. / 566 liter Upright Freezer FFU20FC4A...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.glacierfreezer.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0688 seconds